DNVGL.com

SY-12 Synergi Plant for RBI onshore using API 581 and API 580

This is an introduction course for the application of Risk Based Inspection (RBI) to safety critical equipment in onshore refinery, petrochemical and gas processing

Contact us:

Training offered on request

Request for training
SHARE:
PRINT:
Synergi Plant for RBI onshore using API581 and API580

Training Information

  • Duration:

    3 days

  • Prerequisite:

    This course does not require participants to be licensed users of the RBI Onshore module n Synergi Plant A working knowledge of asset integrity management for new or ageing pressure and process equipment and piping is recommended. Alternatively, experience of design, fabrication, operation or maintenance of pressure systems and associated codes/standards is recommended.

  • Course:

    SY-12 Synergi Plant for RBI onshore using API 581 and API 580

Description

This is an introduction course for the application of Risk Based Inspection (RBI) to safety critical equipment in onshore refinery, petrochemical and gas processing. The course will teach you the qualitative and quantitative RBI methodology within API 581 and API 580.

The following topics are covered:

  • Damage mechanism assignment
  • Probability of failure
  • Consequence of failure and risk calculations
  • Interpretation of assessment results
  • Formulation of inspections plans   

This training applies to the refining, petrochemical and oil and gas industries.

Learning objectives

This API 581 course will help you apply RBI technology. Upon completion of the course you will understand inspection planning via probability and consequence of failure calculation in accordance with API 581. API 580 presents guidelines for developing a RBI programme whereas API 581 provides RBI methods to establish a risk based inspection programme. The exercises are based on typical pressure vessels, heat exchangers and piping.

Target group

The course is aimed at the downstream and midstream onshore refinining, petrochemical, gas processing industries. It is suitable for integrity, materials or corrosion engineers, non-destructive testing engineers and in-service inspectors, plant and maintenance engineers and planners; and associated engineering contractors and consultants.